The linear guided guillotine shears HESSE ES are low-priced and economic machines particularly for the employment in the workshop environment. The cutting angle is not adjustable, the cutting gap adjustment is done from the front by two set screws. The folding up back gauge is positioned either manually by plus/minus buttons and digital read-out or as option by a NC preselection system.
back gauge
Standard digital read-out ERD 100 for back gauge position and cutting length adjustment
The standard back gauge with a range of 750 mm is installed on linear guidances free from play and is moved on ball screws with max. 120 mm/sec. The back gauge can be lifted up at the rear position to cut sheets with unlimited length..
NC preselection system ENC 100 (option)
NC preselection system ENC 100 (option)
• Multistepmode (program mode)
• Touch n’ Go mode (input of measurement and cut)
• Programmable back gauge
• Automatic relieve
• Programmable number of strokes
• Program saving
standard equipment
• digital read-out
• mot. back gauge 750 mm on ball screws, folding up
• cutting length adjustment
• cutting gap adjustment
• finger guard
• 2 sheet support arms
• squaring arm with T-slot, tilting stop and scale
• cutting line illumination
• balls in table
• independent hydr. down holders
• moveable foot switch with emergency stop button
• oil filling
• light barrier on machines back
• machine and equipment according to the CE regulations
optional equipment
• NC preselection system ENC 100
• angle stop 0 – 180°
• pneumatic sheet support system
• longer squaring arms and sheet support arms
attention: Acrobat Reader required
HESSE+CO Maschinenfabrik GmbH IZ NOE-Sued - Straße 4 Objekt 8 - Austria-2351 Wiener Neudorf
Tel. +43/2236/638 70-0 - Fax +43/2236/636 62 office@hesse-maschinen.com
